Setup Instructions - Intex Krystal Clear C1500 Owner's Manual

Filter pump 12 v~, 50 hz, 15 a hmax 1.0 m, hmin 0.19 m, ipx5 max. water temperature 35 c
Hide thumbs Also See for Krystal Clear C1500:
Table of Contents

Advertisement

POOL OUTLET - STRAINER & PLUNGER VALVE SETUP ( optional )
The strainer grid prevents large objects from jamming and/or damaging the filter pump.
The plunger valve assembly prevents water from flowing into the filter pump while the
filter cartridge is being placed or cleaned. If your pool has an inflatable top ring, install the
strainer, nozzle and plunger valve before inflating the pool liner top ring. The parts
numbers here onward, refer to the parts depicted in the Parts List section of this manual.
To install, do the following:
1. In a counter-clockwise motion unscrew
plunger valve union from the threaded
strainer connector (14) (see drawing 1).
Be careful not to lose the step rubber
washer (11). Place the plunger valve on
the ground in a safe place.
2. In a counter-clockwise motion unscrew
the strainer nut (12) from the threaded
connector (14). Leave the flat
washer (13) on the connector (14).
3. Install the strainer and plunger valve at the
lower position of pool outlet (marked "+").
From the inside of the pool liner insert
the connector (14) into one of the
pre-cut holes with the washer remaining
on the connector to be placed against
the inside of the liner wall.
4. Before assembly, lubricate the threads
with a petroleum jelly. Then, with the flat
side of the strainer nut (12) facing the
outside wall of the liner in a clockwise
motion screw the strainer nut (12) back
onto the threaded connector (14) (see
drawing 2).
5. Finger tighten the strainer nut (12) onto
the threaded connector (14).
6. Grasp the plunger valve assembly. Make
sure the step washer (11) is in place.
7. In a clockwise motion screw the plunger
valve union back onto the threaded
connector (14) (see drawing 3).
8. In a clockwise motion turn the plunger
valve handle to close position. Ensure the
plunger valve is securely closed. This will
prevent water from flowing out during
filling of the pool (see drawing 4).
SAVE THESE INSTRUCTIONS
(108GS) MODEL 636G FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/23/2022
12
English
1
2
1
2
INSIDE
LINER WALL
13
14
19
3
1
2
4
INSIDE
LINER WALL
Page 6
108
GS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

636g

Table of Contents