GE JKP27 Owner's Manual page 17

The oven door must be closed and all controls must be set correctly for the cycle to work properly.
How to Delay the Start of Cleaning
Press the SELF CLEAN pad.
Using the HOUR and MIN + or –
pads, enter the desired clean time.
Press the DELAY START pad.
Using the HOUR and MIN + or –
pads, enter the time of day you want
the clean cycle to start.
Press the START pad.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad and rinse thoroughly with a
vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
www.GEAppliances.com
The door locks automatically. The display
will show the start time. It will not be
possible to open the oven door until
the temperature drops below the lock
temperature and the LOCKED light
goes off.
When the LOCKED light is off, open
the door.
NOTE: On models with touch pad controls for
both ovens, you can set a delay clean in both
ovens at the same time. The second oven set will
automatically delay the start of cleaning until the
end of the first oven's clean cycle.
To recall the start time of the second oven set,
press the DELAY START pad on the controls for
the second oven.
You cannot set the oven for cooking
until the oven is cool enough for the
door to unlock.
If the shelves become hard to
slide, wipe the shelf supports with
cooking oil.
17