GE JKP27 Owner's Manual page 24

Before You Call For Service...
Troubleshooting Tips
Problem
"F— and a number
or letter" flash
in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Fan noise
24
Possible Causes
You have a function
error code.
If the function
code repeats.
A fuse in your home may
be blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
This is normal in a
new oven and will
disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
A cooling fan may
automatically turn
on and off to cool
internal parts.
What To Do
• Press the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be pressed
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• This is normal. The cooling fan will turn off and on.