Operation - HUSTLER 4200 Owner's Manual

6
12
5
1. Ignition Switch
2a. Throttle Lever (4200, 4400 4420 & 4600)
2b. Throttle Lever (4300 & 4500)
3. Choke Lever (4300 & 4500 only)
Ignition Switch
Throttle
Lever
(Models 4200 & 4400)
(Models 4420 & 4600 not
shown)
Figure 3-2
Controls
For general location of the controls described in this
section, refer to Figure 3-1.
1. Ignition switch (Fig. 3-2) – Models 4200,4400, 4420
and 4600. A four-position switch: off, pre-heat, run
and start. With key inserted, rotate it counterclock-
wise for engine pre-heat, then rotate full clockwise for
728444 Rev. 11/02

OPERATION

2b
10
9
1
13
2a 4
3
7
11
8
4. Electric Clutch Switch
5. Neutral Lock Levers
6. Steering Control Lever
7. Pump Clutch Lever
Figure 3-1
Electric Clutch
Switch
I I g g n n i i t t i i o o n n
( ( M M o o d d e e l l s s
S S w w i i t t c c h h
4 4 3 3 0 0 0 0 & &
4 4 5 5 0 0 0 0 ) )
C C h h o o k k e e
L L e e v v e e r r
8. Parking Brake
9. Attachment Lift Lever
10. Auxiliary Control Lever
11. Hour Meter
start; release key when engine fires, and switch will
automatically return to RUN position.
Models 4300 and 4500. A three-position switch: off,
run and start. With key inserted, rotate it clockwise to
start. Release key when engine fires, and switch will
automatically return to RUN position.
2. Throttle (Figs. 3-2 and 3-3) – a mechanical link
connected to the engine governor for controlling
engine rpm. On models 4200/4400/4420/4600 (Fig. 3-
2), move lever up to increase engine rpm, move down
to decrease engine rpm. On models 4300 and 4500
(Fig. 3-3), move lever down and forward to increase
engine rpm, pull up and back to decrease engine rpm.
3. Choke control (Fig. 3-2) – a cable link to manual
engine choke, models 4300 and 4500 only. Move up
for cold starting, move down for normal run.
3-1
12. Warning Lights
13. Seat Latch
T T h h r r o o t t t t l l e e l l e e v v e e r r
( ( M M o o d d e e l l s s 4 4 3 3 0 0 0 0 & & 4 4 5 5 0 0 0 0
o o n n l l y y ) )
Figure 3-3