Operation; Safe Operating Practices; Control Panel - HUSTLER Z Diesel Operator's Manual

Safe Operating Practices

Refer to the Safety Precautions section of this manual for
operational and personal safety information.

Control Panel

E
A
C
F
D
B
A. Deck clutch switch
B. Ignition switch
C. Oil pressure light (Non
Tier 4 engines)
D. Temperature warning
light
Figure 3-1
C E
A
F
D
B
A. Deck clutch switch
B. Ignition switch
C. Engine warning light
(Tier 4 engines)
D. Temperature warning
light
Figure 3-2
603695

OPERATION

G
I
E. Glo-plug
F. Alternator warning
light
G. Fuel gauge
H. Temperature gauge
I. Hour meter
G
I
E. Glo-plug
F. Alternator warning
light
G. Fuel gauge
H. Temperature gauge
I. Hour meter
C
A
B
H
A. Deck clutch switch
B. Ignition switch
C. Engine warning light
(Tier 4 engines)
D. Temperature warning
light
IMPORTANT: When access is required under the seat
platform and the seat is equipped with the optional arm
rests, make certain to place the control arms in the park
brake position and pivot the arm rests upward before placing
the seat platform in the full forward position to prevent arm
rest damage.
A. Deck clutch switch (Figure 3-1, Figure 3-2, Figure 3-3) —
this switch engages the deck. Pull the switch up to
engage and push switch down to disengage the
H
clutch.
IMPORTANT: For additional clutch information refer to
the Mower deck operation section of this manual.
B. Ignition switch (Figure 3-1, Figure 3-2, Figure 3-3) — a
three position switch: "OFF", "PREHEAT/RUN", and
"START". With key inserted, rotate it clockwise to
"PREHEAT/RUN" position. After pre-heat has occurred,
rotate the key to the "START" position; release key
when engine starts, and switch will automatically
return to the "RUN" position.
C. Oil pressure light (Figure 3-1) — (Non Tier 4 engines
only) this light comes on when the ignition switch is
placed in the RUN position and stays lit until the
engine is running and a safe oil pressure is developed.
If light comes on during operation, shut engine off
immediately and locate and correct the problem.
Engine warning light (Figure 3-2, Figure 3-3, ) — (Tier 4
engines only) This light will flash once during engine
starting to show that the system is operating properly.
This light will also begin to flash an error code when a
problem is detected by the engine controller. Refer to
the Hustler
®
115164) for additional information.
3-1
E I
D
F
G
E. Glo-plug
F. Alternator warning
light
G. Fuel gauge
H. Temperature gauge
I. Hour meter
Figure 3-3
Z Diesel General Service Manual (P/N
H
REV J