How To Play Media - Kenwood DNX9960 Instruction Manual

Basic Operation

How to play media

7 Disc media
0
Press the [0] button to open/close the
front panel.
If a disc is already inserted, it is ejected
by pressing the [0] button.
7 iPod
To disconnect the iPod, stop the
playback by touching the [0] button
on the source control screen, and then
disconnect the iPod. See <Source
Control Screen> (page 34).
7 USB device
To disconnect the USB device, touch the
[0] button on the source control screen,
and then disconnect the USB device. See
<Source Control Screen> (page 26).
16 DNX series DNX9960/ DNX7160/ DNX7020EX
7 SD card (DNX series only)
This SD card slot is used to upgrade the
Navigation System.
For how to upgrade the Navigation
System, refer to the instruction manual of
the navigation system.
0
1 sec.
Press the [0] button for longer than 1
second to open the front panel.
Inserting the SD card
Hold the SD card with the label side up
and the notched section on the right,
and insert it into the slot until it clicks.
Removing the SD card
Push the SD card until it clicks and
then remove your finger from the card.
The card pops up so that you can pull
it out with your fingers.
Press the [0] button to close the front
panel.
⁄
• The playback starts automatically after loading
the media or connecting the device.