Blomberg DW 24100 B Installation Manual page 18

o
B
s
A
o
p
t
s
A
o
r
B
t
s
A
t
C
B
C
C
Lock the toe kick brackets as shown with the plastic
tab in the figure C by pushing the plastic tab on the
dishwasher into the teeth of the bracket (C).
3. Now attach the toe kick to the bracket with the
two (Ø 3 / 16 " x 1 / 4 " - Ø 4mm x 6mm) screws and
the caps provided as follows.
If the enclosure height is below 33 1 / 16 " (840mm)
use only "o" labelled toe kick (toe kick without slots).
Installation should be done following the steps
illustrated in the Figures A, B and C respectively.
1. Bend tabs on toe kick (o) inwards (A).
2. Secure toe kick to brackets with screws (t) as
shown in the supply bags (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 33 1 / 16 " (840mm)
use "o" and "p" labelled toe kicks together. Make
sure the slotted toe kick "p" is on the outside so you
can adjust height of the toe kick. Installation should
be done following the steps illustrated in the figures
A, B and C respectively.
1. Align the toe kick (o) and (p) (A).
2. Secure toe kicks to brackets with screws (t) after
adjusting the height of the slotted toe kick (p) (B).
3. Attach caps (s) as shown in the supply bags (C).
If the enclosure height is above 34 1 / 4 " (870mm) use
"o" and "r" labelled toe kicks together. Make sure
the slotted toe kick "r" is on the outside so you can
adjust height of the toe kick. Installation should be
done following the steps illustrated in the figures A,
B and C respectively.
1. Align the toe kick (o) and (r) (A).
2. Secure toe kicks to brackets with screws (r) after
adjusting the height of the slotted toe kick (t) (B).
3. Attach caps (s) as shown in the supply bags (C).
15
USA