Installing The Water Dispenser Line - Samsung Refrigerator User Manual

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 138 ~ 862 kPa is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be fi lled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly fi lled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
Water line installation kits are include with
unit. You can fi nd it in freezer drawer.
Parts for water line Installation
Water line fi xer and screws
Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifi er to malfunction.
22_ setting up
4. After connecting the water supply to the water
fi lter, turn your main water supply back on
and dispense about 3L to clear and prime the
water fi lter.
Connecting the water line to the
refrigerator
1. Remove the cap from the water line on the unit
and insert the compression nut of the water
line into the water line on the unit.
2. Connect the water line on the unit with the
water line in the kit .
3. Tighten the compression nut onto the
compression fi tting. There should be no gaps
between (A, B & C )
4. Turn water on and check for any leakage.
Pipe connector
CAUTION
Close Main Close Main
Water pipe Water pipe
No gap No gap
Close Main Close Main
Water pipe Water pipe
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get
a snug, leak-free connection.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
No gap No gap
Water Line Water Line
from Kit from Kit
Before being used, the leakage in these
places should be examined.