Assembly Of The Blade And Trimmer Head; Assembling The Blade Guard And Grass Blade; Assembling The Blade Guard And Clearing Blade - Husqvarna 245 RX Operator's Manual

Assembly of the blade and trimmer
head
It is extremely important that
the disc drive's/support
flange's guide engages
correctly in the cutting
equipment's centre hole when
assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
!
WARNING!
Do not attach any blade to the unit without
proper installation of all required parts.
Failure to use the proper parts can cause
the blade to fly off and seriously injure the
operator and/or bystanders.
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter "Technical
data" . If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
IMPORTANT INFORMATION
The machine must be equipped with the correct
handlebars, blade guard and harness if either a
clearing blade or grass blade are to be used.
Assembling the blade guard and
grass blade
• The guard (A) is fitted
using 4 screws (L) and the
support plate (M) as set
out in the diagram.
NOTE! Use the
recommended blade guard.
• Fit the drive disc (B) on
the output axle.
• Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D),
support cup (E) and
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the blade guard as possible. The nut is
tightened when the spanner is turned against the direction of
rotation (left-hand thread).
24
– English
ASSEMBLY
G
F
E
D
A
B
C
L
M
Assembling the blade guard and
clearing blade
• The guard (A) is fitted
using 4 screws (L) as set
out in the diagram.
NOTE! Use the
recommended blade
guard.
• Fit the drive disc (B) on
the output axle.
• Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D) and
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3.5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
blade guard as possible.
The nut is tightened when
the spanner is turned
against the direction of
rotation (left-hand thread).
• When slacking off and
tightening the saw blade
nut, the hands may be
injured by the blade teeth.
Always hold your hand
protected by the blade
guard. This is facilitated
by the use of a long box
spanner. The illustration
shows the area in which
you should keep the box
spanner.
L
A
G
F
D
B
C