Table of Contents
Advertisement
Removing the SAN Volume Controller 2145-CF8 operator-information panel cable
Use these instructions when you are prompted to remove the operator-information panel cable from the
SAN Volume Controller 2145-CF8.
DANGER
Multiple power cords. The product might be equipped with multiple power cords. To remove all
hazardous voltages, disconnect all power cords.
This service action assumes that:
v The node is turned off. If you must turn off the node, ensure that its data is mirrored and
synchronized, and that there are no dependent volumes, as described in MAP 5350 in the IBM System
Storage SAN Volume Controller 2145 Troubleshooting Guide.
v The power cables are disconnected.
v The top cover is removed.
Perform the following steps to remove the operator-information panel cable:
1. Read the safety information to which "Preparing to remove and replace parts" on page 20 refers.
2. Disconnect the cable from the rear of the operator-information panel.
3. Disconnect the cable from the connector above the Video/USB cable connector on the right side of the
node, as shown in Figure 226.
The following illustration shows the cable routing for the operator-information panel cable.
Figure 226. Disconnecting the SAN Volume Controller 2145-CF8 operator-information panel cable
1 Operator-information panel connector
2 Operator-information panel cable
4. Lift the cable from the node.
5. Replace the cable before proceeding.
204
IBM SAN Volume Controller Hardware Maintenance Guide
1
2
Advertisement
Table of Contents
