Brinkmann 5 Burner Gas Grill Owner's Manual page 30

Step 16
Press the two raised
points on the back of
the bezel into the
corresponding holes
on the side burner
front panel.
Note:
Align bezel with stop pin toward
bottom as shown.
Step 17
Insert the two screws that are already
attached on the side burner valve
through the corresponding key holes
on the side burner front panel and
bezel, from the back of the side
burner front panel. Depending on the
side burner valve, you will be using
either the outside key holes (Figure 1),
or the inside key holes (Figure 2). Pull
the valve downward or upward to lock
into place. Do not tighten the two
screws at this step.
Step 18
Remove pre-attached cotter pin from
side burner foot. Insert the side burner
into burner base through the top of
the side table (Figure 3) and make
sure the side burner valve inserts into
the burner venturi (Figure 4).
Step 19
Insert the side burner foot in the
bracket hole. Then use cotter pin to
secure the side burner. (See Below)
Now tighten the two screws from
Step 17.
Step 20
Attach side burner igniter lead wire to
the electrode as illustrated.
29
Cotter Pin
Side Burner
Foot
Figure 1
Stop Pin
Figure 3
Figure 4
Side
Burner
Valve
Valve
Nozzle
Igniter Lead Wire
Figure 2
Side
Burner
Burner Venturi
Electrode
Side Burner
Bracket