Installation - Fujitsu FLASH-CAN-64P-350-PMC User Manual

FLASH-CAN-64P-350-PMC
Chapter 3 Installation

3 Installation

Remove carefully the board from the shipping carton.
Check first if there are any damages before power on the evaluation board.
For the power supply a DC input voltage of 9 V – 12 V is recommended. The positive
voltage (+) must be connected to the centre, and ground (GND) must be connected to
the shield of the connector X12!
After power-on, the green power-on LED (D16) should be on. If the LED does not light
switch off the power supply and check the default jumper settings.
By default, the evaluation board is equipped with a MB96F356 and the device has been
programmed with a test program. So after power-on a running light for the eight user LEDs
can be seen. Furthermore, a welcome string is output with 9600 baud on both UART
channels (UART"A" / UART"B"). Please use 1:1 cable for the PC-connection.
The in-circuit programming allows the user to program it's own application into the Flash-
memory. How to program the Flash memory is described in chapter 4.
If the board is used as an emulator target board, switch off the power supply and remove the
microcontroller from the socket. Now the probe cable can be mounted into the socket. Take
care of pin 1 marking onto the socket and fix the probe cable with screws.
Do not use other probe cable than MB2198-504 or MB2147-540 only!
Connect the probe cable to the emulation pod. Check all DIP-switch-settings of the
evaluation board and the emulation pod.
For the power on sequence the emulator system must be switched on first, after that, switch
on the evaluation board. Please look at the corresponding user manuals for the emulator
how to set up the emulator system. After the power on the 'Reset'-LED of the emulator must
be off and the 'Vcc'-LED must be on.
If the Reset LED is still lighting, check the DIP-switch-settings of the emulator system and
the power supply of the evaluation board.
Note:
Some customers experience connectivity problems when connecting the MCU into
the socket adapter. Only the small red screwdriver available in your box should be
used to connect the cover (HQPACK) onto the socket (NQPACK).
If the four screws are not tightening equally, then it may cause a poor contact.
Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems
then please loosen the screws and tighten again the screws equally.
Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will
contaminate inside of connector.
© Fujitsu Microelectronics Europe GmbH - 7 - UG-960008-10