Connectors; Power Connector (X12); Edge Connector (X1, X2); Uart"A", Uart"B" Connector (X3, X5) - Fujitsu FLASH-CAN-64P-350-PMC User Manual

6 Connectors

6.1 Power connector (X12)

The following figure shows the power connection jack X12. This connector is used to
connect an external unregulated DC power supply voltage (9 V - 12 V DC) to the evaluation
board.
Connector X12:
It is recommended to use 9 V to keep the power dissipation to a minimum. Otherwise, an
additional heat sink for the linear voltage regulator might be necessary.

6.2 Edge connector (X1, X2)

All pins of the microcontroller are directly connected to X1 and X2 as follows:
Connector
X1 (1 – 32)
X2 (33 – 64)
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
On the PCB, the corresponding pin numbers of the IC are written next to the connector pins.

6.3 UART"A", UART"B" connector (X3, X5)

Two 9-pin D-Sub female connectors are used
for the serial interface UART"A" and UART"B".
TXD is the transmit output, RXD is the receive input.
The DTR or RTS signal can be used to generate a reset.
Please use 1:1 cable for PC-connection.
UG-960008-10
FLASH-CAN-64P-350-PMC
Chapter 6 Connectors
Shield is connected to ground (GND)
Centre is connected to positive voltage (+)
MCU Pins
1 – 32
33 – 64
Connectors X3, X5:
- 22 - © Fujitsu Microelectronics Europe GmbH
GND DTR RxD TxD
5
9
CTS RTS DSR
1
6