i
Usually, you now have 30 seconds to ini-
tiate the next step.
Press previously programed button ;, =
X
or ? of the integrated garage door opener
until the door closes.
The rolling code synchronization is then
complete.
Notes on programing the remote control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated garage door
opener. The signal is not recognized during
programing. Comparable with Canadian law,
some U.S. garage door openers also feature a
"break".
Proceed as follows:
if you live in Canada
R
if you have difficulties programing the
R
garage door opener (regardless of where
you live) when using the programing steps
Press and hold one of buttons ; to ? on
X
the integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
Release the button.
X
Indicator lamp : flashes yellow.
Press button B of garage door remote
X
control A for two seconds, then release it
for two seconds.
Press button B again for two seconds.
X
Repeat this sequence on button B of
X
remote control A until indicator lamp :
lights up green.
If indicator lamp : turns red, repeat the
process.
Continue with the other programing steps
X
(see above).
Problems when programing
If you are experiencing problems programing
the integrated garage door opener on the
rear-view mirror, take note of the following
instructions:
Check the transmitter frequency of garage
R
door drive remote control A. This can usu-
ally be found on the back of the remote
control.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz .
Replace the batteries in garage door
R
remote control A. This increases the like-
lihood that garage door remote control A
will transmit a strong and precise signal to
the integrated garage door opener in the
rear-view mirror.
When programing, hold remote control A
R
at varying distances and angles from the
button that you are programing. Try various
angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
If another remote control for the same
R
garage door drive is available, repeat the
same programing steps with this remote
control. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote
control A.
Note that some remote controls only trans-
R
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Press button B on remote control A again
before transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
Once programed, the integrated garage door
opener A will assume the function of the
garage door system's remote control. Please
Features
213
Z