Ashtray; Cigarette Lighter; Points To Observe Before Use - Mercedes-Benz SLS AMG Operator's Manual

Ashtray

i
You can remove the ashtray insert and
use the resulting compartment for stow-
age.
! The stowage space under the ashtray is
not heat resistant. Before placing lit ciga-
rettes in the ashtray, make sure that the
ashtray is properly engaged. Otherwise, the
stowage space could be damaged.
Example: Coupe
To open: briefly press the middle of
X
cover :.
The stowage compartment opens.
To remove the insert: slide insert ; for-
X
wards in the direction of the arrow.
Remove insert ;.
X
To re-install the insert: place insert ;
X
into the holder and press it in the opposite
direction of the arrow until it engages.
To close: fold down cover :.
X

Cigarette lighter

G WARNING
You can burn yourself if you touch the hot
heating element or the socket of the cigarette
lighter.
In addition, flammable materials can ignite if:
the hot cigarette lighter falls
R
a child holds the hot cigarette lighter to
R
objects, for example
There is a risk of fire and injury.
Always hold the cigarette lighter by the knob.
Always make sure that the cigarette lighter is
out of reach of children. Never leave children
unsupervised in the vehicle.
Example: Coupe
Select key position 2 with the Start/Stop
X
button ( page 119).
Y
To open: briefly press the middle of
X
cover :.
The stowage compartment opens.
Press in cigarette lighter ;.
X
Cigarette lighter ; will pop out automati-
cally when the heating element is red-hot.
To close: fold down cover :.
X
12 V sockets

Points to observe before use

Select SmartKey position 1(
X
using the Start/Stop button.
The sockets can be used for accessories with
a maximum current draw of 180 W (15 A)
each, e.g. bulbs or chargers for mobile
phones.
If you use the sockets for long periods when
the engine is switched off, the battery may
discharge.
i
You can also use the sockets when the
ignition is switched off. An emergency cut-
out ensures that the on-board voltage does
not drop too low. If the on-board voltage is
too low, the power to the sockets is auto-
Features
203
page 119)
Y
Z