Toshiba Carrier RAV-SP180KRT-UL Installation Manual page 27

+001111052201_00Ta.book Page 26 Friday, November 20, 2009 11:45 AM
High-Wall Type
Manual address setup procedure
(Procedure example 1)
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
3
-2,
4
-2,
5
-2
7
1
1
Procedure
Push simultaneously
seconds or more. After a while, the display part
flashes as shown below. Check the displayed
CODE No. is [10].
• When the CODE No. is other than [10], push
button to erase the display and repeat procedure
from the first step.
(After pushing button, operation of the
remote controller is not accepted for
approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
(* Display changes according to
the model No. of indoor unit.)
2
Procedure
Every pushing
in the group control is displayed in order. Select the
indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan
and louver of the selected indoor unit operate.
7
3
-1,
4
-1,
5
-1,
3
-3,
4
-3,
5
-3,
2,6
+ + buttons for 4
button, the indoor UNIT No.
– 26 –
3
Procedure
1. Using temp. setup
specify CODE No. [12].
(CODE No. [12]: Line address)
2. Using timer time /
the line address from [3] to [2].
3. Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
Indoor UNIT No. before setup change is displayed.
4
Procedure
1. Using temp. setup
specify CODE No. [13].
(CODE No. [13]: Indoor address)
2. Using timer time /
the indoor address from [3] to [2].
3. Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
Indoor UNIT No. before setup change is displayed.
Installation Manual
/ buttons,
buttons, change
/ buttons,
buttons, change
EN
26-EN
Toshiba