Fujitsu ETERNUS DX100 S3 Operation Manual page 86

Chapter 5 Expansion Functions
5.2 Installing Additional Drive Enclosures
The connectors on the cable with the "n" symbol are connected to the DI (OUT) ports on the nearest
•
enclosure.
6
Connect the DI (IN) port of IOM#0 in the drive enclosure that is to be added to the DI (OUT) port of
IOM#0 in the nearest drive enclosure with the cable between enclosures (mini SAS HD cable).
The following figure shows how the cables between enclosures are connected when drive enclosure 2 is
added.
Drive enclosure 2
(drive enclosure
that is to be added)
Drive enclosure 1
7
Connect the power cord.
(1)
Connect the power cord to the drive enclosure.
Each enclosure has two (or four) power supply units. Make sure that power cords are connected
to all the power supply units.
(i)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Operation Guide (Basic)
Connect here
Connect here
Connect the power cord plugs to the power inlets of the power supply units.
Copyright 2014 FUJITSU LIMITED
86
P3AM-7662-04ENZ0