Care Of Your Energysaver; Cleaning; Fan Filter - Rinnai RHFE-309FT Operation And Installation Manual

CARE OF YOUR ENERGYSAVER

Cleaning

Your heater requires very little maintenance, but the following information will help you to keep it
looking like new and working efficiently.
• Unplug electrical cord before cleaning.
• All parts of the heater can be cleaned using a soft, damp cloth and a mild detergent.
• DO NOT use solvents or abrasives to clean any parts.
Care for the Humidifier Tray: if the humidifier tray gets dirty, wash in warm soapy water.
How to clean: when heater is cold, remove the lower cover panel and pull out the humidifier tray from
appliance. Ensure there is no water in the tray. If there is water in the tray, Keep the tray level to avoid
spilling then wash in warm soapy water.

Fan Filter

To protect the appliance internals from dust
particles or lint, a filter is situated at the rear of the
heater.
If the filter becomes blocked, the filter indicator
will flash to indicate that it should be cleaned. Clean
the filter weekly during the heating season. Dusty or
clogged filters reduce the air flow through the
appliance reducing heating effectiveness.
• DO NOT remove filter when appliance is
operating.
• If the filter requires cleaning, clean filter whilst
the appliance is not operating.
The 'ON' indicator
shows error code 14.
Note: If you do not clean the filter at regular
intervals and the Filter Indicator
to remain flashing, then the appliance will stop.
You must clean the filter before operating the
heater again.
• DO NOT use the heater with the filter indicator
flashing as this may cause overheating.
• DO NOT wait for the filter indicator to flash
before cleaning filters, how to clean the Fan
Filter: Dust: Use duster or vacuum to remove
dust. Oil: Wash the fan filter with a mild
detergent. Drain off the water and dry the filter.
Ensure to fit the Fan Filter back in the appliance after cleaning.
DO NOT operate appliance without filter in place.
WARNING
Regularly check the outside flue terminal to make sure it is clear from plant growth and from other
obstructions. Refer "SAFETY" on page 2 for additional requirements.
Rinnai Australia
will flash & the display
9
is allowed
8
14
Remove filter by pulling straight
up and out from appliance.
8
13 Energysaver® - Operation & Installation Manual
®
8
9
1