Troubleshooting - Clarion VX401 Owner's Manual & Installation Manual

GENERAL
Replace with a fuse of the same
amperage. If the fuse blows again,
consult your store of purchase.
Press the reset button with a thin
rod.
Note:
When the Reset button is pressed,
turn off the ACC power.
*
When the Reset button is
pressed, frequencies of radio sta-
tions, titles, etc. stored in memory
are cleared.
Consult your installation center.
The microprocessor has malfunc-
tioned due to noise, etc.
Incorrect wiring.
Display is not accurate.
Power does not turn on. (No sound Fuse is blown.
is produced.)
Nothing happens when buttons are
pressed.
The remote control unit does not
work.
Direct rays of the sun fallon the
light-receptive part of the remote
control unit.
When direct rays of the sun fall
on the light-receptive part of the re-
mote control unit, it may not work.
The battery of the remote control
unit is dead or there is no battery in
the remote control unit.
Check the battery of the remote
control unit.
DVDPLAYER
Disc cannot be loaded. A disc is already loaded. Eject the disc before loading the
new one.
There is foreign matter already in
the disc slot.
Remove the foreign matter, or
consult a service station.
Sound skips or is noisy. Disc is dirty.
Clean the disc with a soft cloth.
Disc is heavily scratched or
warped.
Replace with a disc in good condi-
tion.
Sound is bad directly after power is
turned on.
Condensation may form on the
internal lens when the car is parked
in a humid place.
Let dry for about 1 hour with the
power on.
Video images are not displayed. The parking brake is not engaged. Check that the parking brake is
engaged.
Disc cannot play with the
display "PARENTAL VIOLATION"
shown.
Feature exceeds set parental level. Release the view limitation or
change the parental level.
See the subsection "Setting up the
parental level"
42
VX401NZ401