Table of Contents
Advertisement
To start an engine with a weak
battery
WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always
wear eye protection when
around batteries.
If your battery is too weak to start the engine,
it should be recharged. (See "Battery" on
page 37).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use your mower
battery to start other vehicles.
To attach jumper cables
•
Connect each end of the RED cable to
the POSITIVE (+) terminal on each
battery, taking care not to short against
chassis.
•
Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of the fully
charged battery.
•
Connect the other end of the BLACK
cable to a good CHASSIS GROUND,
away from the fuel tank and battery.
IMPORTANT INFORMATION
Do not allow the units to touch each other.
To remove cables, reverse order
•
Disconnect BLACK cable first from chassis and
then from the fully charged battery.
•
Disconnect RED cable last from both batteries.
28
English-
OPERATION
Jumper cables connection
8011-642
Advertisement
Table of Contents
