3. Belt Adjuster, Mower Deck
Remove the plate (four screws) and lubricate
with a grease gun, one zerk, until grease is
forced out.
Use only good quality molybdenum
disulphide grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually
maintains a good quality.
IMPORTANT INFORMATION
Be spartan and remove excess lubricant so
that is does not come into contact with
belts or belt pulley drive surfaces.
4. Outer belt wheels
Lubricate using a grease gun, one zerk, until
the grease squeezes out. Lubricate on both
sides.
Use only good quality molybdenum
disulphide grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually
maintains a good quality.
5. Throttle and Choke Cables, Lever
Bearings
Lubricate the cable ends at the carburetor
with the oil can. Move the controls to the end
points and lubricate again.
The throttle cable is also lubricated at the
control when the control console is removed.
LUBRICATION
The belt adjuster grease zerk
Lubricating the outer belt wheels
Throttle and choke cables by the carburetor
8011-576
8011-432
8011-605
51
English-