In The Gravel Trap; Removing/Installing Mirrors; Rors - BMW S 1000 RR Rider's Manual

In the gravel trap

6
with BMW Motorrad DTC
90
DTC deactivation
On very loose surfaces (for ex-
ample in a gravel trap of a race
track), DTC's attempts to con-
trol propulsive power might re-
duce drive to the extent that the
rear wheel no longer turns. Un-
der these circumstances, BMW
Motorrad recommends temporar-
ily deactivating DTC.
Bear in mind that the rear wheel
will spin on the loose surface and
z
close the throttle in good time
before you reach a firm surface.
Then reactivate DTC.
Removing/installing
mirrors
Removing mirror
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
OE
On each side, remove nuts 1
and remove the mirrors.
Secure fairing 2 to fairing
bracket 3 on left and right.
If cable ties are used, affix
adhesive tape as protection at
the points where chafing might
occur.
Use the HP Race Cover
Kit from BMW Motorrad
to cover the screw holes and
restore the security of the
mounting.
Installing mirrors
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove the fairing-panel
fasteners.