CITROEN C8 2002 Handbook page 9

GENERAL SPECIFICATION: LIFTING AND SUPPORTING THE VEHICLE
Lifting by means of a two-column workshop lift
WARNING : The removing of components such as the engine/gearbox, rear sub-
frame etc, can cause a displacement of the centre of gravity: Use a lift equipped
with retaining devices to keep the body stable on the lift.
Without body clamps.
Place the lift's guide pads at each jacking point.
WARNING : To prevent any risk of the vehicle toppling, it is prohibited to
remove mechanical components.
With body clamps
WARNING : These clamps are fitted only on FOG lifts.
Position the clamps at the sill in the jacking points provided, screw heads oriented
towards the outside of the vehicle. Tighten the clamps using the gudgeon pin and,
after tightening, engage the pin in the hole (A).
Towing (front).
Lift the blank with the aid of the flat part of the towing eye (1) and then screw the
eye home.
NOTE : The towing eye is to be found on the front panel inside the engine com-
partment.
Towing (rear).
Lift the blank (1) and screw the towing eye home.
E2AF004D E5AF022D E2AK02YD E2AK02XD
7