Notes On Switching On/Off - Siemens SIMpad SL4 User Manual

Notes on Switching On/Off

When the screen is dark, press the
to the screen and above the control key. SIMpad is ready for operation
immediately after activation. The screen shows the user interface as it
was when you last switched the device off.
To switch off SIMpad, press
While on, if SIMpad has not been used for a time, it switches off
automatically to save power. If there is a power supply (AC power or if the
battery is sufficiently charged) no data is lost when the device switches
off automatically (see "Notes on battery" on Page 14).
To switch back on again, press the button
Reset function
Should the system "get stuck" (evident from the fact that input is no
longer possible), you can perform a software reset. Tap on Start →
Programs → Tools → Software Reset and in the following dialog box tap
on Yes.
If the fault does not clear, you can perform a manual reset. On the
underside of the device you will find a small hole marked RESET. Press the
button in this hole using the stylus. SIMpad is restarted. If a simple reset
does not clear the fault, please refer to "Troubleshooting" , see Page 89.
After a reset you are requested to enter the date and time again.
An existing Internet connection is not disconnected if you switch
off SIMpad during a dial-up connection.
button (on/off) on the right next
.
.
Getting started
13