Sharp GX10i Service Manual page 70

GX10i
*5: The melody playback test is also available in the manual test mode F51.
<Startup>
1. Fit a battery in the set to start the manual test mode.
2. Press the keys, "5"
3. Press the following keys to switch operations.
Key
" "
" "
"0"
"Right
Soft"
" "
" "
"Centre"
4. Press the key "Centre" to return to the initial screen with the display, "Diag Param Saving".
5. Press the "End/Power" key to finish operation.
*6: Handling diag calibration data.
Contents of diag calibration data:
1. 4 Kinds of A/D Adjustment values.
2. Camera adjustment data (Dark current, white flaw).
CONFIDENTIAL
"1" "Right Soft", to start the manual test mode F51 (Melody Test).
Description
Selecting melody tone.
Selecting melody tone.
Ring tone playback.
Playback/Stop.
Key touch tone output.
Volume control.
Volume control.
End
WR
Diag
RD
Figure 86 Handling Diag Calibration Data
Contents
Select the next melody by toggling.
If the final melody is selected, further selection
is unavailable.
Select the preceding melody by toggling.
If the default melody is selected, further selection
is unavailable.
Toggle the selected ring tone between playback
and stop. Default: –16 dB
0: Stop 1: Playback
Toggle the key touch tone between ON and OFF.
0: Stop 1: Output (DTMF: –16dB)
Turn up the volume by 1 level.
During playback of ring tone: Ring tone is changed.
During key touch tone output: Incoming audio
volume is changed.
Turn down the volume by 1 level.
During playback of ring tone: Ring tone is changed.
During key touch tone output: Incoming audio
volume is changed.
Shifting from this mode to the initial screen
SVDEVPRM
SRAM
LDDEVPRM
2 – 66
F_ROM Diag area