Sharp GX10i Service Manual page 27

(2) Loader error message table (on the phone)
No. Message
1 COMPLETE!
2 ERASE READY
3 WRITE READY
4 BRT CHANGING
5 P ERASING ...
6 WRITING ...
7 FLASH ERS OK!
8 SUMCHECK ...
9 SUMCHECK END
10 SUM = XXXX h
11 SUM ERROR!
12 PARITYERR!
13 FRAMINGERR!
14 OVERFLOW!
15 ERS_REC_ERROR
16 BRT_REC_ERROR
17 DAT_REC_ERROR
18 ADR_REC_ERROR
19 END_REC_ERROR
20 HDR_ERROR!
21 ODD_ERROR!
22 SEQ_ERROR!
23 VPP ERROR!
24 PRT_ERROR!
25 ERS_ERROR!
26 WRT ERROR!
27 ERASE CHK ERR
28 WRITE CHK ERR
29 ADR = XXXXXXXX
30 STR =XX
• No.1 to No.10 are information messages. These messages are displayed in the normal operation.
No.11 to 30 are error messages. Messages No.22 to No.28 indicate Flash-oriented errors. The error address (No.29)
and status (No.30) are also displayed at the same time.
CONFIDENTIAL
Figure 45 An example of the error message
The downloading operation is completed.
Preparing for the erasing operation.
Preparing for the program data.
Changing the baud rate.
Erasing the program data.
Loading the program data.
The program data is successfully erased.
Calculating the SUM value of the written data.
The calculation of the SUM value of the written data is completed.
The SUM value of the written data.
Serial communication error (Check SUM error).
Serial communication error (Parity bit error).
Serial communication error (Framing error).
Serial communication error (Buffer overflow error).
Serial communication error (Failed to receive the erase record).
Serial communication error (Failed to receive the change record of baud rate).
Serial communication error (Failed to receive the data record).
Serial communication error (Failed to receive the address record).
Serial communication error (Failed to receive the end record).
Serial communication error (Received the undefined record).
Serial communication error (Odd error).
The Flash operation was failed (Sequence error).
The Flash operation was failed (VppLow error).
The Flash operation was failed (Protect error).
The Flash operation was failed (Erase error).
The Flash operation was failed (Write error).
An error occurred while verifying the erasure.
An error occurred while writing the data.
The location of the error is displayed.
The time of the error occurrence is displayed.
2 – 23
Description
GX10i