Changing The Intensity - Drolet YUKON Instructions Manual

• Set the oil flow control knob at "1". As soon as the oil starts flowing into the burner, set it back to
"0".
• Open the door and pour 2 to 3 ounces (app. 75 ml) of lighting gel or wood alcohol into the burner.
NOTE : USING LIGHTING GEL IS BETTER AND SAFER.
• With a long wood match or a BBQ lighter, ignite and close the door. The burning gel will allow the
burner and exhaust system to warm up.
• After a few minutes (before the fire goes out), set the oil flow control knob at "1".
• Increase the oil flow by one position every ten minutes until you reach the desired intensity.
Note : Never leave matches, paper, or other materials in the burner.
IF LIGHTING FAILS, ALWAYS WAIT FOR THE BURNER TO COOL DOWN
TO ROOM TEMPERATURE BEFORE USING WOOD ALCOHOL AGAIN.
IF, FOLLOWING A LIGHTING FAILURE, THE BURNER FINDS ITSELF
WITH AN EXCESS QUANTITY OF OIL, ALL OF THE OIL MUST FIRST BE
REMOVED BEFORE LIGHTING THE STOVE AGAIN.
•
Waiting 10 minutes before increasing the oil flow by one position will allow the flame to stabilize and will
prevent soot build-up.
•
No waiting is needed when decreasing the oil flow.
LIGHTING (CONT'D)

CHANGING THE INTENSITY

Page 10 of 30