Adjusting The Mower Deck - Husqvarna LZ5227TXPKOA, LZ6123LTKOA, LZ6127TKOA, LZ6130TXPKOA, LZ7230TXPKOA Operator's Manual

Adjusting the Mower Deck

WARNING!
Before performing any service or adjustment checklist:
1. Engage the parking brake.
2. Place the blade-switch in the disengaged position.
3. Turn ignition switch to "OFF" position and remove the key.
4. Make sure the blades and all moving parts have completely stopped.
5. Disconnect the spark plug wire from all spark plugs and place the wire where it
cannot come in contact with the plug.
Leveling
1. Position the mower on a level, preferably
concrete, surface.
2. Check the pressure in all four tires. See
"Technical Data" on page 66.
3. Rotate blades to align front to back.
4. Set the cutting height to 4".
5. Measure front blade tip, should be 4"
from ground, if not turn locknut on top of
front eyebolt till measurement is
achieved. Check blade tip at front on
opposite front blade. Adjust locknut on
front eyebolt as necessary.
6. Check rear blade measurement, should
be 4 1/4" from ground, if not turn locknut
on top of rear eyebolt to achieve
measurement. Repeat procedure on
opposite side.
Adjusting Cutting Height
1. Raise and secure the deck height lever
to the transport position (6").
2. Position blade tip so it is straight forward.
3. Measure from the cutting edge of the
blades to a flat level surface. The
distance should be 6" (150 mm).
4. Drop and secure the lever at (for
example) the 2" cutting height. Measure
as above. The distance should be 2"
(50 mm).
48
English-
MAINTENANCE
3
4
1. Front eyebolt
2. Front locknut
3. Rear locknut
4. Rear eyebolt
Leveling the mower deck, eye bolt version
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
2
1
8011-601-1