Adjusting The Mower Deck; Cutting Blades - Husqvarna 96795390500 Operator's Manual

MAINTENANCE

Adjusting the Mower Deck

Leveling deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to
the correct pressure. See Technical Data /
Transmission. If tires are under or over inflated,
the deck cannot be correctly adjusted. Raise the
deck to the highest (transport) position.
The deck must be adjusted slightly higher in the
rear.
NOTE: To insure the precision of the leveling
procedure, the mower deck drive belt must be
installed before leveling the deck.
1. Wear heavy gloves. Turn each outer blade tip
to align front to rear with the deck side-to-side.
2. Measure from the floor surface up to the
bottom of the blade tip on the discharge side
of the mower deck. Record the measurement.
3. Move to the opposite side, check that
measurement is the same. If adjustment is
required—with a 3/4" or adjustable wrench,
turn the lift link adjustment nuts on either
side counter clockwise to lower or clockwise
to raise. Adjust until both measurements are
equal.
26
4. Turn any blade to align with the deck front-to-
rear. If the front blade tip does not measure
1/8" to 1/2" higher in the rear—with a 5/8"or
adjustable wrench, turn the nuts on the front
suspension linkage. Clockwise raises the front
of the mower, counter clockwise will lower the
front. Adjust nuts until rear of mower deck is
positioned level to 1/8" higher in the rear than
the side-to-side measurement.
NOTE: For illustration, the front foot rest has been
removed. The adjustment can be made without
removal.
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, additional adjustments may be
required to get the desired cut.

Cutting Blades

For the best mowing results, it is important that
blades are correctly sharpened and not damaged.
Replace blades that have been bent or cracked
when hitting obstacles.
Let the service workshop decide if a blade with
large nicks can be repaired/ground or must be
replaced. Balance the blades after sharpening.
Check the blade mounts.
CAUTION! Blades are sharp.
Protect your hands with gloves
and/or wind heavy cloth around
the blades before handling.
The sharpening of blades must be carried out
by an authorized service workshop.
Blade replacement
1. Remove blade bolt by turning counter
clockwise.
2. Install new or resharpened blade with
stamped GRASS SIDE facing towards
ground/grass (down) or THIS SIDE UP facing
deck and cutter housing.
3. Seat the blade's opening firmly onto the cutter
housing.