Service And Adjustments; To Remove Mower; To Install Mower - Husqvarna LOYTH20F42T Operator's Manual

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER-
VICE OR ADJUSTMENTS:
1. Depress brake pedal fully and set parking brake.
2. Place attachment clutch in "DISENGAGED" position.
3. Turn ignition key to "STOP" and remove key.
4. Make sure the blades and all moving parts have completely stopped.
5. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR

TO REMOVE MOWER

1. Place attachment clutch in "DIS EN -
GAGED" position.
2. Lower attachment lift lever to its lowest
position.
3. Remove mower belt from electric
clutch pulley (M).
4. Disconnect front link (E) from mower
- remove retainer spring and washer.
5. Go to either side of mower and discon-
nect mower suspension arm (A) from
chassis and rear lift link (C) from rear
mower bracket (D) - remove retainer
springs and washers.
6. Go to other side of mower and discon-
nect the suspension arm and rear lift
link.
CAUTION: After rear lift links are dis-
connected, the attachment lift lever will be
spring loaded. Have a tight grip on lift lever
when changing position of the lever.
7. Slide mower out from under right side
of tractor.

SERVICE AND ADJUSTMENTS

B
C
D
20

TO INSTALL MOWER

Be sure tractor is on level surface and
engage park ing brake.
1. Lower attachment lift lever to it's lowest
position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before slid-
ing mower under tractor.
2. Slide mower under tractor until it is
centered under tractor.
3. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS - Position hole
in arm over pin (B) on outside of tractor
chassis and secure with washer and
retainer spring.
4. Repeat on opposite side of tractor.
M
A
H
F
E