Belts - Hoover Vacuum Cleaner Owner's Manual

belts

The belts are located under the bottom plate of the
cleaner and should be checked from time to time to
be sure they are in good condition.
The flat (wide) belt is described below; the other is
described under "Brushroll replacement".
when to replace
3.9 To check the flat belt, remove bottom plate as
shown. Replace belt if it is stretched, cut or
broken.
how to replace
WARNING
!
Agitator brushroll can start suddenly. Unplug
cleaner before turning it over.
3.9 Place handle in low position and turn cleaner
over so bottom side is up.
Remove the 4 screws as shown with a Phillips
screw driver.
Lift off bottom plate (A).
3.10 Flat belt (B) operates the self-propel feature
and indirectly drives the brushroll.
Remove used belt (B) from large pulley (C) and
discard.
3.11 With lettering on outside of belt, slide new belt
over motor shaft (D).
3.12 Place other end of belt over large pulley (C)
while rolling the pulley in direction shown.
3.13 Reposition bottom plate and 4 Phillips head
screws. Tighten screws securely.
what to buy: belt
Use only genuine HOOVER
cleaner. When purchasing a new belt, ask for
Flat belt - HOOVER
If desired, additional belts can be purchased at
Hoover.com or 1-800-944-9200.
!
® belts with your
® part No. 38528035.
3.9
A
3.11
D
3.13
13 Actual model may vary from images shown.
Meijer.com
3.10
B
C
3.12
C