Maintenance; Filter Bag - Hoover Vacuum Cleaner Owner's Manual

attaCh hose
2.16 Push ON/OFF switch to OFF position.
Align end of extra reach hose with projections (I)
over slots (J) in dirt duct.
2.17 Slide hose into (J) and twist hose to lock it into
place. (To detach hose, reverse procedure.) Attach
wands or tools to the other end of hose.
CheCk baG indiCator
2.18 The indicator (K) will begin to show red as the
filter bag fills with dirt.
There are three conditions that will cause the indicator
to become completely red:
1. If the bag is full; change the bag.
2. If very fine materials have been picked up,
clogging the bag pores; change the bag.
3. If there is a blockage at the front of the cleaner,
in the hose, tools or at the bag opening; remove
the blockage (see "Clearing blockages" section).
Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.

filter baG

when to replace
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
IMPORTANT
All new carpet has loose fibers which can fill the
bag quickly while vacuuming. This type of
debris does not activate the "Check bag"
indicator available on some models.
what to buy: filter bag
Use only genuine HOOVER® bags with your
vacuum. When purchasing a new bag, ask for
HOOVER® HEPA Type Y Bag Part #902419001
or Carbon HEPA Type Y Bag Part #902481001.
Actual model may vary from images shown.
2.16
I
J
2.18

3. MaintenanCe

Very fine materials, such as face powder,
cornstarch, fireplace ashes or fireplace soot,
may seal the filter bag and may cause it to burst
even though it is only partially full of dirt. When
cleaner is used to remove material of this
nature, change filter bag often.
10
K
CAUTION
!
Meijer.com
2.17
J
!