Introductory Information About The Cd Mode; Memory Card - Skoda Amundsen+ Operating Instructions Manual

Introductory information about the CD mode

Insert CD
›
Insert a CD, with the labelled side facing up, into the CD slot
matically drawn in. The play function will start automatically.
Eject CD
›
Press the button – die CD is ejected.

If the ejected CD is not taken out within 10 seconds, it will be retracted again for
safety reasons.
CD not legible
If a CD is inserted which cannot be read by the unit, a pop-up window is displayed
with a note. Press the function key
CD to jump
Uneven road surfaces and strong vibrations may cause the CD to jump.
Formation of condensation
When it is cold and after rain showers, moisture can deposit in the CD drive (con-
densate). This can effect the CD jump or impair the play function. In such cases,
wait until the moisture has dissipated.
Notes for the care of the CDs
If a CD is soiled, never clean the CD with circular movements but rather from the
inside to the outside with a soft lint-free cloth. In case of severe layers of dirt we
recommend to clean the CD with a commercially available CD cleaner. Also in this
case, do not clean the CD with circular movements but rather from the inside to
the outside, and then let it dry.
WARNING
The CD player is a class 1 laser device. Opening the CD player produces a risk
of injury through non-visible laser radiation.
CAUTION
Only audio-CDs (CD-A) and MP3-CDs can be played in the internal drive. Never
■
place DVDs into the internal drive – irreparable damage may result.
Never insert CDs with the designation "Do not insert in drives without a drawer"
■
or Eco Disc into the internal drive.
12
MEDIA mode
until it is auto-
9
, the CD is moved to the removal position.
OK
Inserting a second CD while a CD is being ejected can damage the CD drive in
■
the unit. After pressing the Eject button
fore the CD is ejected. During this time the lock in front of the CD case is open. Be
sure to wait until the CD has been fully ejected before you try to insert a new CD.
If the CD has mechanical damage or is incorrectly or not fully inserted, the fol-
■
lowing message appears on the screen " Error: CD". Check the CD and insert in
properly into the drive. if the message "Error: CD" appears, try using another CD
and visit a specialist garage
If the inside temperature of the unit is too high, no CDs will be accepted. The
■
unit switches into the last active operating mode.
Never use liquids such as benzine, paint thinner or record cleaner, otherwise
■
the surface of the CD may be damaged!
Never expose the CD to direct sun light!
■
Only write on the CD with appropriate writing tools.
■
Do not affix anything to the CD!
■
Note
If the function key is inactive, no Audio CD has been inserted or the inserted
CD
■
Audio CD is not readable.
It is possible that CDs protected by copyright and self-made CD-R and CD-RW
■
are not returned at all or only in certain circumstances.
The national copyright laws that apply in your country must be observed.
■
The CD player contains no parts that need servicing or that can be repaired. If
■
the CD player is defective, visit a specialist garage.

Memory card

Inserting a memory card
›
Push the memory card into the memory card lose
the front right until it "locks into place". The play function will start automatical-
ly.
Taking out a memory card
›
In the "System and sound settings" menu, choose the menu point "Remove SD
card" » page 8, System and sound settings.
›
Press the inserted memory card. The memory card "jumps" into the initial posi-
tion.
there is a delay of a few seconds be-

with the trimmed edge to
16
Ð
