Accessories - Drill Master 350x User Manual

Reversing or Replacing Your
Diamond Sharpening Wheel
1.
2.
3.
4.
18
Disconnect your Drill Doc-
tor, make sure machine is
cool, then remove Wheel
Access Cover.
Use wrench supplied with
your Drill Doctor to lock
sharpening wheel in place.
With Phillips-head screwdriv-
er, remove the two screws
and wheel retainer.
Remove worn wheel by twist-
ing slightly and lifting wheel
off shaft. Install new wheel
and reinstall wheel retainer
and screws. Don't over-tight-
en mounting screws. Remove
the wrench and replace the
Wheel Access Cover before
turning on the machine.
www.drilldoctor.com

Accessories

Order Accessories through our website: www.Drill-
Doctor.com, or by contacting us at the phone num-
ber listed on the Warranty page (page 20), or at the
retailer where you purchased your
Standard Diamond Sharpening Wheel
(180 grit)
DA31320GF
Coarse Diamond Sharpening Wheel
(100 grit)
DA31325GF
WARNING:
The use of any accessory other than one rec-
ommended in this user's manual may present
a risk of personal injury.
www.drilldoctor.com
Drill Doctor ® .
19