Starting Up And Configuring The Router; Powering On The Router - HP MSR20-1X Series Installation Manual

The power supply is as required.
•
• The router is correctly connected to the console terminal and other devices. Parameters are correctly
configured on the console terminal.
CAUTION:
The check after installation is very important. The stability, grounding of the router, and power supply can
affect the operation of the router.

Starting up and configuring the router

Before starting up the router, you must set up the configuration environment. After that, you can power on
the router and perform initial configuration for the router.

Powering on the router

Switch on the power source
•
• Turn on the power switch on the router
WARNING!
Before powering on the router, locate the power switch of the power source so that you can disconnect the
power supply in time in case of an emergency.
Startup process
After power-on, the router initializes its memory, and then runs the extended BootWare. The following
information appears on the terminal screen:
System is starting...
Do you want to check SDRAM? [Y/N]
Booting Normal Extend BootWare........
The Extend BootWare is self-decompressing.....................
Done!
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2010-2011 Hewlett-Packard Development Company, L.P.
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
CPLD Version
HP MSR20-10 BootWare, Version 2.24
: Feb 16 2011
: MPC8323E
: 16KB
: 333MHz
: DDR SDRAM
: 256MB
: 266MHz
: 1024KB
: 1.0
30
*
*
*