Vehicle Immersion - Polaris RANGER XP 900 Owner's Manual

POLARIS Variable Transmission (PVT) System
PVT Drying
There may be some instances when water is accidently ingested into the PVT system. Use
the following instructions to dry it out before operating.
1. Position the vehicle on a level surface. Place the transmission in PARK. Stop the engine.
2. Remove the clutch cover drain plug. Allow the
water to drain completely. Reinstall the drain plug.
3. Start the engine.
4. Apply varying throttle for 10-15 seconds to expel
the moisture and air-dry the belt and clutches. Do
not apply heavy throttle for more than 10 seconds.
5. Allow the engine RPM to settle to idle speed.
Apply the brakes. Shift the transmission to the
lowest available range.
6. Test for belt slippage. If the belt slips, repeat the
process.
7. Take the vehicle to your dealer for service as soon as possible.

Vehicle Immersion

NOTICE: If your vehicle becomes immersed, major engine damage can result if the machine is not
thoroughly inspected. Take the vehicle to your dealer before starting the engine.
If it's impossible to take your RANGER to a dealer before starting it, follow the steps outlined
below.
1. Move the vehicle to dry land or at the very least, to water below the floorboard.
2. Dry any water present in the air box. Filter replacement is required if water is present.
3. Dry any water present in the intake manifold.
4. Remove the spark plugs. Turn the engine over several times using the electric start.
5. Dry the spark plugs and reinstall, or replace with new plugs.
6. Attempt to start the engine. If necessary, repeat the drying procedure.
7. Take the vehicle to your dealer for service as soon as possible, whether you succeed in
starting it or not.
8. If water has been ingested into the PVT, follow the PVT Drying procedure.
MAINTENANCE
Drain Plug
59