Vehicle Immersion - Polaris UTV Series 10 2x4 Owner's Manual

MAINTENANCE AND LUBRICATION

Vehicle Immersion

If your vehicle becomes immersed, take it to your dealer before
starting the engine. Major engine damage can result if the
machine is not thoroughly inspected.
If it's impossible to take your UTV to a dealer before starting it, follow
the steps outlined below.
1. Move the vehicle to dry land, or at
the very least, to a water level below
the floor.
2. Disconnect the fuel pump wires.
3. Remove the spark plug.
4. Loosen the carburetor drain screw (1).
5. Turn the engine over several times
with electric start.
6. Dry the spark plug and reinstall, or
install a new plug.
7. Tighten the carburetor drain screw.
8. Reconnect the fuel pump wires.
9. Attempt to start the engine. If necessary, repeat the drying
procedure.
10. Take the machine to your dealer for service as soon as possible
whether you succeed in starting it or not.
NOTE: If water has been ingested into the PVT follow the procedure
on page 71 for drying.
72
CAUTION
1