REFRIGERANT LINES REMOVAL/INSTALLATION
1. Remove the battery.
2. Discharge the refrigerant from the system. (See
3. Remove the washer tank. (L.H.D. only) (See
4. Remove the air cleaner cover, air cleaner element and air cleaner case. (See
REMOVAL/INSTALLATION.)
5. Remove the charcoal canister.
6. Remove the No.3 engine mount. (L.H.D. only)
7. Remove the shroud panel. (See
8. Remove the right splash shield.
9. Remove the right mud guard. (L.H.D. only)
Caution
• • • • If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and
abnormal noise will occur. Always immediately plug all open fittings after removing any
refrigeration cycle parts to keep moisture or foreign material out of the cycle.
10. Remove in the order indicated in the table. Do not allow compressor oil to spill.
11. Install in the reverse order of removal.
BASIC SYSTEM
U9
RECOVERY.) (See
T58 WASHER TANK
S119 SHROUD PANEL
U9
CHARGING.)
REMOVAL/INSTALLATION.)
F10 INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
A6E851661460W01
U
U25