Advertisement
Advertisement
Table of Contents
Related Manuals for Nanni T4.165
Summary of Contents for Nanni T4.165
- Page 1 Instruction manual Marine Diesel engine T4.165 T4.180 T4.200 970313790 15072010-D...
-
Page 2: Technical Characteristics
Technical characteristics ENGINE SPECIFICATIONS T4.165 T4.180 T4.200 Cycle 4 strokes Diesel Max. power - kW (hp)* 121,5 (165) 132,5 (180) 147,2 (200) Number of cylinders / Arrangement 4 in line Displacement (cm 2 982 Fuel timing before TDC (°) 11.8° at 3400 rpm, ECM controlled... - Page 3 Main parts of the engine Non-binding photographs. The coupled equipment and accessories can vary according to your level of equipment. 1. Alternator 13. Heat exchanger 2. Alternator belt 14. Coolant fi ller port 3. Starter 15. Sea-water pump 4. Air fi lter 16.
-
Page 4: Oil Level
Then, rinse the fi lter with clear water. Press the fi lter to remove any water and to dry it. NANNI DIESEL has designed a cleaning kit which is suited to certain models of air fi lters. - Page 5 Inspection and adjustment of the levels Fuel fi lter Attention ! : Always sponge up any fuel which may have spilled Observe the environment protection rules. A. Fuel fi lter cartridge The fuel fi lter is a throw-away type fi lter. The fi reguard envelope and the water probe must be preserved and reinstalled correctly (if equipped).
- Page 6 Inspection and adjustment of the levels Alternator belt Warning !: Perform this operation with the engine stopped. A. Alternator B. Alternator belt Visually check the belt for excessive wear, frayed cords, etc. If any defect has been found, replace the drive belt. If the belt has chunks missing from the ribs, it should be replaced.
- Page 7 Inspection and adjustment of the levels Coolant level Warning !: When fi lling the cooling system, the coolant level must be checked after 10 minutes of use since the system purges itself automatically. Top up if necessary. A. Coolant plug Turn the fi...
-
Page 8: Installation Inspection
(air needed : T4.200 : 1520 m /h, T4.180 : 1370 m The hull outlet must be located 15 cm above the water line. T4.165 : 1260 m /h). The tube between the exhaust box and the hull outlet must... - Page 9 Installation inspection Fuel supply system The fuel tank of the engine must be placed as possible at the same level or slightly higher than the engine. The return pipe must be placed under the mini level of the fuel tank. The fuel pump is capable of sucking the fuel to a height of 0.5m.
-
Page 10: Instrument Panel
High pressure turbo. This alert indicator indicates that the air pressure in the turbocharger is too high. Faulty system. This indicator is lit when there is a failure on the electronic system of the engine. If this indicator comes on, contact an authorised Nanni Diesel dealer. - Page 11 Instrument panel Operation of an engine equipped with an A4 and / or C4-T panel: To start the engine : 1. Put the throttle in the neutral position. 2. Put the key into the ON/STOP ignition. 3. Turn the key a quarter turn to the right. All the warning lights will come on and it will make a sound signal. This stage allows you to check that these elements are working properly.
- Page 12 E-mail : contact@nannidiesel.com © 2009 - Nanni Industries SAS The images, text and information contained in this document are based on the product’s features at the time of publication. Nanni Diesel reserves the right to modify this document without prior notice.