Installing Batteries; Setting Up Your Components - One for All 6-Device Universal Remote User Manual

O F A 6 U
NE OR LL

INSTALLING BATTERIES

1. On the remote control's back,
push down on the top of the
battery cover (where indicated
by the arrows). Then slide the
battery cover out.
2. Obtain two (2) new AAA
alkaline batteries. Match the +
and – marks on the batteries to
the + and – marks in the battery
case, then insert the new
batteries.
6 Installing Batteries
R
NIVERSAL EMOTE
C
ONTROL
3. Slide the battery cover back into
place. The tab should click when
the cover is locked.
4. Test the remote control by first
pressing POWER and then any
mode key (e.g., TV ). If the
batteries are inserted correctly,
the LED (red light) will blink
once.
NOTE: When batteries are low, the
remote control will blink 5 times after
each key press. The remote will stop
operating when the batteries need
replacement. The permanent memory
retention ensures that your codes are
stored permanently even during
battery replacement.
SETTING UP YOUR
COMPONENTS
The One For All 6L Universal Remote
Control (URC-6020 B00) is
preprogrammed at the factory to
operate a Sony TV, DVD and VCR, a
Motorola Cable Box, a Sony Tivo PVR/
DVR, and a Pioneer Receiver. To
control devices other than the default
brands, perform the following steps;
otherwise skip this section.
NOTE: For Combo Device control, see
the next section.
1. Turn on a device (e.g., TV, VCR
or DVD player) and, if
applicable, insert media (e.g.,
cassette or disc).
NOTE: Please read steps 2 through 4
completely before proceeding.
Highlight or write down the codes and
device you wish to program before
starting step 2.