Razor E300 Series Owner's Manual page 8

REPAIR AND MAINTENANCE
Reassembly
5
Install the chain onto the rear
wheel sprocket. Slip wheel axle
into the frame slots. See rear wheel
hardware sequence on prior page.
Push the chain tensioner down to
create slack in chain. Hand tighten
rear axle locknuts.
8
Thread the brake cable through the brake adjuster barrel,
through the large spring, and into the small hole in the side of
the anchor bolt. Position the cable to the original location (as
indicated by the slight cable kink) and tighten securely.
10
Replace the chain guard.
Turn power switch "OFF" before conducting any maintenance procedures.
q Front Tire Replacement
Tools required: Two (2) 16 mm wrenches.
1
Using two (2) 16 mm wrenches, loosen the
front axle bolts by turning the wrenches counter
clockwise. Remove wheel and install replacement
wheel. Note the sequence of hardware.
6
Verify chain is properly
installed on each sprocket and
E300
tensioner is correctly positioned
at the bottom of the chain.
9
Tighten the locknuts on the rear axle.
Test the brake to verify proper function
before riding. Readjust as needed
Cable Guide
Bracket
Nut
Washer
Washer
Brake Plate
7
Install the cable guide
bracket to the frame and brake
plate using bolt, washers, and
nut. Do not tighten.
Tighten the cable guide bracket bolt.
7
Meijer.com
Frame
Bolt
Front wheel hardware
Note:
sequence.
9-4
9-5
9-5
9-3
9-2
9-1
Right Side (Throttle)
9-5 - Spacer
9-4 - Washer
Fork
9-3 - Washer
9-2 - Spring Washer
9-1 - 16 mm Locknut
Middle
9-6 - Front Axle Bolt
Left Side (Brake)
9-5 - Spacer
9-4 - Washer
Fork
9-3 - Washer
9-2 - Spring Washer
9-1 - 16 mm Locknut
9-1
9-2
9-3
9-6
9-4