Table of Contents
Advertisement
Chapter 7 RS-232 Interface
Introduction
This chapter describes how to set up the digital scanner with an RS-232 host. The RS-232 interface is used to
connect the digital scanner to point-of-sale devices, host computers, or other devices with an available RS-232 port
(e.g., com port).
If the host is not listed in
to match the host.
NOTE The digital scanner uses TTL RS-232 signal levels, which interface with most system architectures. For
system architectures requiring RS-232C signal levels, Motorola offers different cables providing
TTL-to-RS-232C conversion. Contact Motorola Enterprise Mobility Support for more information.
Throughout the programming bar code menus, default values are indicated with asterisks (
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
Table
7-2, refer to the documentation for the host device to set communication parameters
*Baud Rate 9600
*
Indicates Default
*
).
Feature/Option
Advertisement
Table of Contents
