Network Settings - Panasonic SC-NE5 Operating Instructions Manual

Network settings

You can wirelessly stream music from an iOS
device (iPhone, iPod, iPad), an Android
a Mac/PC to this system's speakers by using the
AirPlay or DLNA feature.
To use these features, this system must join the
same 2.4 GHz wireless network as the AirPlay
compatible device (l 5) or the DLNA compatible
device.
≥ It is also possible to use AirPlay without a wireless network
router. (l 14, "Directly streaming to this system (AirPlay)")
Preparation
≥ Place this system close to the wireless network
router.
1
Turn this system on.
2
Follow the chart below to choose the network
setting method.
Does your wireless network router
Yes
right,
l
"Method 1"
iPod touch/iPhone/iPad?
Is the iOS version 5.0 or later?
Yes
11,
l
"Method 2"
≥ If you want to perform wireless setting with
your Mac/PC, or you want to apply the
10 advanced setting, try "Method 4" on page 12.
10
VQT4X66
TM
support WPS?
No / Do not know
Are you using an
No
12,
l
"Method 3"
≥ To cancel this setting in the middle, press [Í] to turn off this
system.
device or
≥ Simultaneous use with other 2.4 GHz devices, such as
microwaves, cordless telephones, etc., may result in
connection interruptions.
≥ For up to date compatibility information on your wireless
network router refer to
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Method 1
If your wireless network router supports WPS
(Wi-Fi Protected Setup
∫ Using the WPS Push Button
Configuration (PBC)
1
Press and hold [s WPS] on the speaker unit.
{. "WPS" flashes on the display.
(The Wi-Fi status indicator blinks blue.)
≥ Complete step 2 within 2 mins.
2
After "WPS" is indicated, press the WPS button
on the wireless network router.
3
The settings are completed when "SUCCESS"
is displayed and the Wi-Fi status indicator
stops blinking and lights in blue.
"FAIL" may be displayed if the connection was not
made within the set time limit. Try the setting
again. If "FAIL" is still displayed, try other methods
on page 11 or 12.
4
Press [OK] on the remote control to exit the
setting.
≥ To use the WPS PIN code, refer to the notes on page 13.
).
TM
The WPS identifier mark
WPS Push Button
Configuration (PBC)
compatible wireless network
router may have this mark.