Network Settings - Panasonic SC-NE5DB Operating Instructions Manual

Network settings

You can wirelessly stream music from an iOS device
(iPhone, iPod, iPad), an Android device or a Mac/PC to
this system's speakers by using the
feature.
To use these features, this system must join the
2.4 GHz wireless network as the AirPlay
compatible device (l 5
device.
≥ It is also possible to use AirPlay without a wireless network
router. (l 14, "Directly streaming to this system (AirPlay)")
Preparation
≥ Place this system close to the wireless network
router.
1
Turn this system on.
2
Follow the chart below to choose the network
setting method.
Does your wireless network router
Yes
right,
l
"Method 1"
iPod touch/iPhone/iPad?
Is the iOS version 5.0 or later?
Yes
11,
l
"Method 2"
≥ If you want to perform wireless setting with your
Mac/PC, or you want to apply the advanced
setting, try "Method 4" on page 12.
10
VQT4U56
AirPlay
or the DLNA compatible
)
support WPS?
No / Do not know
Are you using an
No
12,
l
"Method 3"
≥ To cancel this setting in the middle, press [Í] to turn off this
system.
≥ Simultaneous use with other 2.4 GHz devices, such as
DLNA
or
microwaves, cordless telephones, etc., may result in
connection interruptions.
same
≥ For up to date compatibility information on your wireless
network router refer to
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Method 1
If your wireless network router supports WPS
(Wi-Fi Protected Setup
∫ Using the WPS Push Button
Configuration (PBC)
1
Press and hold [s WPS] on the speaker unit.
{. "WPS" flashes on the display.
(The Wi-Fi status indicator blinks blue.)
≥ Complete step 2 within 2 mins.
2
After "WPS" is indicated, press the WPS button on
the wireless network router.
3
The settings are completed when "SUCCESS" is
displayed and the Wi-Fi status indicator stops
blinking and lights in blue.
"FAIL" may be displayed if the connection was not
made within the set time limit. Try the setting again.
If "FAIL" is still displayed, try other methods on page
or
11 12.
4
Press [OK] on the remote control to exit the
setting.
≥ To use the WPS PIN code, refer to the notes on page 13.
).
TM
The WPS identifier mark
WPS Push Button
Configuration (PBC)
compatible wireless network
router may have this mark.