Identification Of Controls; Front Panel - NAD T 737 Owner's Manual

Av surround sound receiver
Hide thumbs Also See for T 737:
Table of Contents

Advertisement

IDENTIFICATION OF CONTROLS

FRONT PANEL

1
2
3
10
1 POWER BUTTON: Press this button to switch ON the T 737. The Standby
LED indicator will turn from amber to blue and illuminate the VFD. Pressing
the power button again turns the unit back to standby mode.
2 STANDBY LED: This indicator will light up amber when the T 737 is
in standby state. When the T 737 is in the ON state, this indicator will
illuminate blue.
3 NAVIGATION and ENTER buttons: These buttons are used to navigate
the T 737 OSD as well as for navigation of DAB (230V version only), XM
(120V version only) tuner functions and iPod. The middle round button
is designated as "ENTER" button; this is normally pressed to complete a
selection, procedure, sequence or other applicable functions.
4 MENU: When listening to DAB (230V version only) or XM (120V version
only) radio, press this button to enable their corresponding digital radio
menu in conjunction with the applicable [
5 LISTENING MODE: Toggle to select through the various Listening
mode options. Depending on the format of the currently selected input
(digital or analog, stereo or multichannel), various listening modes are
available. Refer also to the item about LISTENING MODE under the
USING THE T 737 – MAIN MENU segment of the OPERATION section.
6 VACUUM FLUORESCENT DISPLAY (VFD): Displays visual information
about the current settings like the active Source, volume level, listening
mode, audio format, applicable RDS/XM/DAB as well as iPod-related
display information and other related indicators. Refer also to the item
about DISPLAY SETUP under the USING THE T 737 – SETUP MENU
segment of the OPERATION section.
6
4
5
6
7 REMOTE SENSOR: Point the AVR 3 remote control at the remote sensor
8 SOURCE [
9 VOLUME: Use this control to adjust the volume level of the speakers.
] and [ENTER] buttons.
7
8
and press the buttons. Do not expose the remote sensor of the T 737 to a
strong light source such as direct sunlight or illumination. If you do so, you
may not be able to operate the T 737 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30
in each direction of the front of the remote sensor.
o
] : Press these buttons to toggle through the input
selections – Source 1, Source 2, Source 3, iPod, Source 5, Multi Front
and Tuner (AM/FM/XM/DAB as applicable). More Sources could be
directly recalled through these buttons upon enabling them at the
Setup Menu. Refer also to the item about SOURCE SETUP under the
USING THE T 737 – SETUP MENU segment of the OPERATION section.
Turn clockwise to increase the volume setting; counter clockwise to
lower it. Refer also to the item about ADJUSTING VOLUME under the
USING THE T 737 – SETUP MENU segment of the OPERATION section.
9
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents