Printing A Test Label - Intermec EasyCoder PM4i User Manual

To achieve the best possible print quality, follow these guidelines:
•
•
•
•
•

Printing a Test Label

When you print a test label, the printer prints the tag type name
on the next available label on the media roll. You can print a test
label from:
•
•
To print a test label from the printer's console
1 On your printer console, press Setup.
2 For Fingerprint printers, navigate to Print Defs > Testprint
8
After you load RFID media, restart the printer or run a
TESTFEED to let the printer identify the RFID media type.
If necessary, modify the TAGADJUST variable to make sure
that the RFID labels are properly aligned with the antenna.
For help, see "RFID,TAGADJUST" on page
If necessary, avoid printing on the thickest part of the label.
For printers running Fingerprint:
• If you are using thermal transfer labels, start with the
ribbon constant set to 80 and the ribbon factor set to 25.
You may need to adjust these values depending on the
type of media you choose.
• To write to Gen 2 RFID tags using the TAGFIELD
command, set the start and length parameters to even
numbers.
For printers running IPL:
• Start with the sensitivity set to 565. You may need to
adjust this value depending on the type of media you
choose.
• To write to Gen 2 RFID tags, set the start and length
parameters of the RFID tag field setup command (a) to
even numbers.
the printer's console.
the printer's home page.
> RFID Test Label, and press Enter.
For IPL printers, navigate to Test/Service > Testprint >
Config > RFIDlabel.
EasyCoder Printer (PM4i, PX4i, and PX6i ) RFID User's Guide
12.