Am/Fm Tuner Operation - Jensen AWM968 Installation And Operation Manual

AM/FM TUNER OPERATION

1
2
3
4
5 AWM968
6
7
8
9
10
25
26
27
30
28 31
Selecting a Band
Press the FM/AM button (6) to directly access tuner mode from any other function mode or to
change between two AM bands (AM1 and AM2) and three FM bands (FM1, FM2 and FM3).
Tuning/Preset Stations
Manual Tuning
Press the TUNE/SEEK/TRACK >>| button (13) to tune the frequency one step higher. Press
the TUNE/SEEK/TRACK |<< button (14) to tune the frequency one step lower.
Seek Tuning
Press and hold the TUNE/SEEK/TRACK >>| or |<< button (13, 14) to automatically tune to the
previous/next strong station.
PUSH/ENTER
22 23 24
PUSH/ENTER
29 32
Preset Stations
Six numbered preset buttons store and recall stations for each AM and FM band.
11
12
13
14
15
16
To store a station, select a band (if needed), and then select a station. Press and hold a preset
17
button for three seconds to store the current station. The corresponding preset number will
appear on the right side of the LCD under the letters "CH".
18
To recall a station, select the preferred band and then press a preset button. The unit will
automatically tune to the corresponding stored station.
19
Automatic Store/Preset Scan (AS/PS)
Automatically Store
20
Press and hold the AS/PS button (26) for more than three seconds, and the unit will
21
automatically scan for and store the six strongest stations for all bands. To stop this function
before the automatic storing is complete, press AS/PS again.
Preset Scan
Briefly press AS/PS to scan all preset stations in the current band. The unit will play each
station for five seconds before moving on to the next station. To stop this function and play the
current station, press the AS/PS button again.
6
AWM968