Please Do Not Return This Product To The Store - Bissell 8910 SERIES User Manual

T
roubleshooting
Cleaner not picking up solution.
Possible Causes
1. ReadyTools dial may be on the
wrong setting for the cleaning job.
2. Nozzle window may not be
properly attached.
3. 2-in-1 tank lid is not properly installed.
4. 2-in-1 tank is not properly seated.
5. Poor tool position.
(Hand held attachments only).
6. 2-in-1 Tank has picked up
maximum dirty water.
Other Maintenance or Service not included above should be performed by an
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call 1-800-263-2535

Please do not return this product to the store

w w w . b i s s e l l . c a
authorized service representative.
Remedies
1. Set ReadyTools dial to either floor
cleaning or tools.
2. Press down firmly on the black
oval gasket at the top window to
make sure the two tabs on the
back of the nozzle window are
snapped into the mating slots in
the main housing.
3. Re-install lid; refer to page 9.
4. 2-in-1 tank must be firmly
seated to function; remove and
reseat 2-in-1 tank.
5. Adjust angle; apply more
downward pressure.
6. Empty 2-in-1 tank, refer to
page 11.
1 - 8 0 0 - 2 6 3 - 2 5 3 5
17