Table of Contents
Advertisement
T
roubleshooting
Reduce Spray or No Spray
Possible causes
1.
Water tank may be empty
2.
Tank may not be seated completely
3.
Pump may have lost prime.
4.
Debris filter on base is clogged
DirtLifter
PowerBrush does not turn
™
Possible causes
1.
The belt is off or broken
2.
The unit is in the upright position
3.
Circuit breaker on machine may have tripped
Cleaner not picking up solution
Possible causes
1.
Tanks may not be seated properly
2.
Clean water/solution tank is empty
3.
Dirty water tank has picked up the maximum amount
of dirty water and the red float door has closed
4.
Red float door in the tank may have closed as a result of
bumping an object or moving machine back and forth too quickly
5.
Front nozzle of machine is clogged
6.
Upper body filter is clogged
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
16
w w w . b i s s e l l . c o m
WARNING:
to reduce the risk of fire, electric
shock, or injury,turn power
off and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.
Remedies
1. Fill clean water/solution tank with hand hot tap water
2. Turn power OFF (0). Remove and reseat tank.
3. Turn power OFF (0) and then back ON (I). Wait one minute,
then depress trigger
4. Use hand to remove debris
Remedies
1. Turn power OFF (0) and unplug unit from outlet. Follow
instructions on page 14
2. Brushes only rotate when unit is reclined using the
detent pedal
3. Turn the machine OFF (0) and unplug from outlet. Check
to see if foreign object is caught in brush roll. Remove
object. Plug machine in to reset circuit breaker
Remedies
1. Pick up both the clean water/solution and dirty water tanks
and reseat them so they fit snuggly on the unit
2. Check fluid levels in clean water tank and refill if necessary
3. Empty dirty water tank. Refill clean water tank with water
and formula. Place both tanks back onto unit
4. Turn the machine OFF (0), allowing red float door to release
into the open position,. Turn the unit back ON (I) to
continue cleaning. Be sure your forward and backward
strokes are completed at a slower pace
5. Use fingers to remove any debris from this area
6. Use fingers to remove any debris from this area
Advertisement
Table of Contents
