Troubleshooting - Bissell 8910 SERIES User Manual

T
roubleshooting
Heater ready light does not illuminate.
Possible Causes
1. The heater switch is not turned ON ( I ).
2. The machine power switch is not
to turned ON ( I ).
Reduced spray or no spray.
Possible Cause
1. Bladder may be empty.
2. Heater tank may be empty.
3. The filter may be clogged.
4. Tanks may not be seated properly.
5. Pump may have lost prime.
6. The Pump belt may be broken.
DirtLifter PowerBrush does not turn.
Possible Cause
1. The brush belt or pump belt
is off or broken.
16
w w w . b i s s e l l . c a
Lift Here
Insert Screwdriver
Blade Here
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
Remedies
1. Turn ON ( I ) the heater
switch.
2. Both switches must be ON ( I )
to activate the heater
ready light.
Remedies
1. Refill bladder with hot tap water.
2. Fill with BISSELL deep Cleaning
formula for cleaning. Fill with
water if rinsing.
3. Clean out flow indicator filter,
page 12.
4. Turn power OFF (O); remove &
reseat tanks.
5. Turn power OFF (O); after 1
minute turn ON and press
trigger.
6. Turn on the machine and check to see
that the DirtLifter PowerBrush turns. If
it does not, refer to #1 below.
Remedies
1. Turn the machine OFF (O) and unplug
from the outlet. To check if the brush
belt or pump belt has broken, you
will need a flat head screwdriver.
Insert the blade end into the lower
slot of the belt access door to release
the lower snap. If necessary, insert
the blade end into the upper slot to
release the upper snap. Examine the
belt for breakage. If broken, please
refer to Replacement Parts on page 19
before calling Consumer Services.
Complete installation instructions
will accompany the replacement belt.
1 - 8 0 0 - 2 6 3 - 2 5 3 5